Samsung Appliance Repair, Silver Spring and Hyattsville
Read the Samsung code off the display before anything gets reset. It points the tech to the part to test first on the visit.
A Samsung code on the display and an appliance that stopped
Silver Spring Appliance Fix sets up Samsung appliance repair for French-door and side-by-side refrigerators, washers, dryers and dishwashers in Silver Spring, Hyattsville and across the Maryland suburbs. On most Samsung appliances the code is the tech's first lead.
Samsung writes one fault several ways. A washer might show 5C, 5E, SC, nd or 1 5C for the same drain problem, and on a dryer an upside-down F is a t. Codes also vary by model, so read us the code exactly as it shows, along with the model number from the tag.
Samsung readouts that don't need a repair
Some of what shows on a Samsung display is a mode or a pause. These come straight from Samsung's support pages.
OF OF, O FF or scrolling bars on the fridge
Cooling Off, also called demo or shop mode. The display works and nothing gets cold. Samsung's exit: hold the top two buttons on the left of the panel for 5 to 8 seconds until it chimes. Some models also need the top right button.
Every icon flashing after plug-in
Samsung calls this a normal self-check after the fridge is plugged in or power returns.
Ice Off blinking
The ice bucket is missing or not seated.
85C on a Family Hub
Low voltage, often from a brief outage. Samsung calls it harmless; hold OK for 3 seconds.
4C2, 4E2 or CE on the washer
The cold supply is running hot because the hot and cold hoses are swapped. Samsung says no service is needed for the washer itself.
Sud or 5Ud on the washer
Too many suds. The washer pauses for a bit to break them down, then carries on.
dn on the washer
A software download. The controls don't respond for about 15 minutes.
Ct on the dryer
The dryer is below freezing or above 104°F, as in a cold garage or a hot laundry closet. Samsung's step is an hour at room temperature.
Samsung fault codes, appliance by appliance
Meanings are from Samsung's US support pages. The last column is where the visit usually starts, and the tech confirms it by testing. Other brands are in the error code library.
Samsung refrigerator codes
| Code | Samsung's meaning | Where the tech looks |
|---|---|---|
| 21E | Freezer fan isn’t turning as expected, often from frost or a door that isn’t sealing | Freezer fan, frost on the evaporator, door gasket, defrost parts |
| 22E, 22C | Fridge fan error, often after a door was left open too long | Fridge-side fan and the ice around it |
| 5E | Fridge defrost sensor | Defrost sensor, then the defrost heater |
| 33E | Ice pipe heater | The heater on the ice maker fill pipe |
| 39E, 39C | Ice maker function | Ice maker module and its water fill |
| 40E, 40C | Ice room fan | The fan that cools the ice compartment in the door |
| 83E | Abnormal compressor current | Compressor and the inverter board that drives it |
| 84C | Compressor lock | Compressor and inverter board |
| 85E, 86E | Compressor under-voltage or over-voltage | Supply voltage at the outlet, then the board |
| 88 88 | Communication fault, possibly after power loss during start-up | Wiring and connections between boards |
| 76C | Water detected in the Autofill compartment | Autofill pitcher seat and water valve |
More on the parts behind these on the refrigerator and freezer repair page.
Samsung washer codes
| Code | Samsung's meaning | Where the tech looks |
|---|---|---|
| 4C, 4E, nF | Not filling | Supply valves, hoses, inlet screens, water inlet valve |
| 5C, 5E, SC, nd | Not draining at the right speed, or at all | Pump filter, drain hose, drain pump |
| OE, OC | Overflow: too much water in the tub | Water level sensor and inlet valve |
| LE, LC, 1E | Water level or leak sensor | Where the moisture came from, then the sensor |
| UE, Ub, Ur | Unbalanced load (Ur means it added water and retried) | The load, then suspension and leveling |
| dE, dC, dL, FL | Door not detected as closed and locked | Door lock assembly, strike and wiring |
| 3E, 3C | Motor (3E can also be a voltage error) | Motor, its wiring and the supply |
| HE, HC | Heater | Heater element and temperature sensor |
| 9C1, PF | Irregular voltage; PF follows an outage or a tripped breaker | The circuit and outlet |
More on the parts behind these on the washer repair page.
Samsung dryer codes
| Code | Samsung's meaning | Where the tech looks |
|---|---|---|
| HC, hE | Too hot, or the heater isn’t hot enough | Lint screen and vent, heater, thermostats |
| tS, tE, tC | Temperature or sensor issue, usually from trapped heat | Exhaust vent, then the thermistor |
| dC, dE, dF | Door, latch or door sensor | Latch and door switch |
| Clg, C80, C90 | Vent blockage test: clogged, about 80% blocked, over 90% blocked | The full exhaust vent run |
| 9C1, 9E | Abnormal supply voltage. On a stacked pair with a multi-control kit, 9C1 can show if the dryer is used within 5 seconds of turning on the washer | The circuit, then the kit and its software |
| AC, AE | Internal communication | Board connections |
| HC2 | Gas ignition | Igniter and gas valve coils |
More on the parts behind these on the dryer repair page.
Samsung dishwasher codes
| Code | Samsung's meaning | Where the tech looks |
|---|---|---|
| 5C, SC, 5E | Can’t drain | Filter, drain hose, disposal connection, drain pump |
| LC, LE | Leak sensor detects moisture | The leak source under the tub |
| 4C, 4E | Water pressure or temperature too low | Supply valve and inlet valve |
| HE | Interior temperature read incorrectly | Heater and temperature sensor |
| HC | Interior too hot | Heater control |
| 1E, IE | Waterwall models: clogged filter. Rotary models: high-temperature heater error | Filter, or the heater circuit |
| 3C | Pump operation error | Wash pump |
| 3E | Incoming water too hot (supply above 176°F) | The water heater feed |
| 9E | Low water level | Fill path and level sensing |
More on the parts behind these on the dishwasher repair page.
Resetting a Samsung: what Samsung itself says
Samsung's advice differs by appliance, and on two of them it amounts to "don't." A reset that clears the code also clears the clue, so write it down first.
- Refrigerator
- Don't unplug it or press the panel to clear a code unless Samsung's steps tell you to. For 83E, 85E, 86E and 88 88, it allows unplugging or switching off the breaker for 60 seconds. A code that comes back needs service.
- Dishwasher
- "Don't try to reset or clear the code before you troubleshoot it," Samsung writes. For HC, and 1E on rotary models, the breaker goes off for 30 seconds, then the empty dishwasher runs a Normal cycle.
- Washer
- Power off for 2 to 3 minutes, then restart. For the not-filling codes, unplug it or flip the breaker for one minute. Blinking lights alone aren't an error unless the washer has also stopped working normally.
- Dryer
- Power off for 2 to 3 minutes for motor, dry time and gas ignition codes. Communication codes get 60 seconds off.
Samsung coverage on compressors, sealed systems and washer motors
Samsung refrigerators carry one year of parts and labor on the whole unit and five years of parts and labor on the sealed system: the compressor, condenser and evaporator. The digital inverter compressor gets longer coverage, 10 years on the compressor part. Labor terms on the compressor vary, and Samsung notes coverage can differ by model, so the warranty card that came with your fridge has the final word.
On washers, Samsung's 10-year term covers the digital inverter motor on washers bought on or after April 1, 2026, and a receipt showing the purchase date is needed for a claim. It doesn't extend to dryers. Dryers, dishwashers, ranges, wall ovens and cooktops carry Samsung's one-year standard warranty.
Warranty terms shape how a repair is handled, so have the purchase date and the model ready when you phone.
Samsung questions from Silver Spring callers
Why does 22E keep coming back on my Samsung fridge?
Can you work on a stacked Samsung pair in a condo closet?
What does the 1 in front of 1 5C mean?
Is a Samsung fridge with 83E worth repairing?
A Samsung code written down and nothing working?
Have it in front of you when we answer. We note that code and the model, and the visit gets booked around it in the first few minutes.